1,Description
The sprayer are high pressure sprayer series. To four-stroke gasoline engine as the driving force, high-pressure piston pump is as the working source, the application of special gun spray height can reach vertical spray 6-8 meters. If you need a higher spray, you can extend the high pressure hose to work on a long pole.
2,Feature
1. Please check carefully before starting each of the fasteners are tightened to ensure that sprayer and motor are mounted on a tripod.
2. Adjust the drive belt and two pulleys to a parallel state , elastic medium.
3. Each locking tube connector to prevent leakage.
4 .Turn off the water before starting the motor switch , loosen the screw regulator , the regulator handle is pulled to the top.
3,Parameter
| Engine type | WDL-160 | ||
| Cylinder diameter | 68mm | ||
| Piston stroke | 45mm | ||
| Displacement | 163mm | ||
| Carburetor | Transistor ignition magnets (non-contact) | ||
| Start method | Recoil start | ||
| Allocation | 20 meters thick tube, 30 meters high pressure outlet pipe, 1.2 m spray gun, 0.9m spray gun | ||
| Sprayer height | 6-8m | ||
| Water tank | 160L | ||
| Spray model | 45A | ||
| Flow | 21-37.5 L/min | ||
| Working Pressure | 2-3.5Mpa | ||
| Dimension | 115*85*95cm | ||
contact informationÂ
Â
1,Description
The sprayer are high pressure sprayer series. To four-stroke gasoline engine as the driving force, high-pressure piston pump is as the working source, the application of special gun spray height can reach vertical spray 6-8 meters. If you need a higher spray, you can extend the high pressure hose to work on a long pole.
2,Feature
1. Please check carefully before starting each of the fasteners are tightened to ensure that sprayer and motor are mounted on a tripod.
2. Adjust the drive belt and two pulleys to a parallel state , elastic medium.
3. Each locking tube connector to prevent leakage.
4 .Turn off the water before starting the motor switch , loosen the screw regulator , the regulator handle is pulled to the top.
3,Parameter
| Engine type | WDL-160 | ||
| Cylinder diameter | 68mm | ||
| Piston stroke | 45mm | ||
| Displacement | 163mm | ||
| Carburetor | Transistor ignition magnets (non-contact) | ||
| Start method | Recoil start | ||
| Allocation | 20 meters thick tube, 30 meters high pressure outlet pipe, 1.2 m spray gun, 0.9m spray gun | ||
| Sprayer height | 6-8m | ||
| Water tank | 160L | ||
| Spray model | 45A | ||
| Flow | 21-37.5 L/min | ||
| Working Pressure | 2-3.5Mpa | ||
| Dimension | 115*85*95cm | ||
contact informationÂ
Â
We can supply both hot rolled or cold drawn flat steel bars. Cold drawn flat steel bars are usually produced by cold drawing through flat shape mould from hot rolled flat steel bars. Some flat steel bars width and thickness are very near like square bar. We may produce by hot rolled steel round bar, too. Our factory has complete and advanced production and inspection, testing facilities, we can control flat steel bar hardness for you, too.
Flat Steel Bar,Carbon Flat Steel Bar,Mild Steel Flat Bar,Cold Drawn Steel Flat Bar
SHANDONG LE REN SPECIAL STEEL CO., LTD. , https://www.lerenspecialsteel.com